EPDM Flat Roof Construction in Brooklyn, NY
EPDM flat roof construction is what BST Roofers does for brownstones, row houses, multi-family and commercial buildings across Brooklyn, from bare deck to finished membrane. Ready to price your build? Call (929) 295-4523.
- Brownstones
- Row houses
- Multi-family
- Commercial
What the build covers
Every layer is planned before the first roll goes down.
Deck inspection and preparation- Insulation laid with tapered slope
- Cover board
- EPDM membrane, seam tape and sealing
- Flashing at parapet walls, curbs and penetrations
- Edge metal and drains
Replacing an older roof instead? See EPDM roof replacement.
The different ways EPDM is attached
| Compare | Fully adhered | Mechanically attached | Ballasted |
|---|---|---|---|
| How it is held | Glued across the deck | Fastened along seams and edges | Stone weight on top |
| Best for | Most Brooklyn rooftops | Larger, open roofs | Decks that carry extra load |
| What to know | Smooth, tidy finish | Fast to install | Adds weight |
We choose the method after looking at your deck.
Why build a flat roof in EPDM
EPDM is a single rubber sheet, so there are fewer seams to fail. It shrugs off sun and weather, and it suits flat and low-slope buildings well.
Long lifespan
Decades with basic upkeep.
One single sheet
Less to leak.
Weather resistant
Built for Brooklyn's sun, rain and winters.
Weighing options? Read how EPDM compares with TPO.
Drainage and details that decide how long it lasts
Water must leave the roof. Tapered insulation gives it a path to the drains, so ponding never sits on the membrane.
We detail drains and scuppers carefully. Parapet and penetration flashing gets the same care, and every seam is sealed and checked before we move on.
- Tapered slope
- Drains & scuppers
- Parapet flashing
- Seams checked
From bare deck to finished roof
-
Deck
Inspected and repaired.
-
Insulation
Laid to drain, with cover board.
-
Membrane
Rolled out and bonded.
-
Flashing
Edge metal and drains finished.
-
Walkthrough
Final check and clean-up.
EPDM flat roof construction FAQ
Straight answers before you book your estimate.
01How long does the build take?
A typical roof takes a few days, depending on size and weather. We confirm the schedule in your estimate.
02Can it go over an existing roof?
Sometimes, if the old layers are dry and sound. Otherwise we tear off first.
03How long does it last, and what does the warranty cover?
EPDM lasts for decades, and the warranty covers workmanship. For pricing, see what EPDM work costs.
04Does it suit a brownstone or a commercial roof?
Yes, both.
Get your free estimate
Would you like a new EPDM roof priced by people who build them? Call (929) 295-4523 or request your estimate. Curious about paying over time? See financing.