TPO membrane roofs · Brooklyn, NY

TPO Roof Replacement in Brooklyn, NY

TPO roof replacement is what BST Roofers does for flat and low-slope roofs across Brooklyn, with a white membrane whose seams are heat-welded into one sheet. Ready to see what your roof needs? Call (929) 295-4523 or book a Free estimate.

Crew welding a white TPO membrane on a Brooklyn flat roof
Full scope

What the replacement includes

We strip the old roof and rebuild it properly.

  • 01Full tear-off of the old roof
  • 02Roof deck check
  • 03Insulation, with tapered insulation where water needs a path
  • 04TPO membrane with heat-welded seams
  • 05Flashing and parapet detail work
  • 06New drains and scuppers, then full clean up
New white TPO membrane meeting a brick parapet on a Brooklyn roof
Five steps

From tear-off to finished roof

  1. 01

    Inspect and measure

    We check the roof and give you a written number.

  2. 02

    Strip and check the deck

    Old layers come off, and any bad decking is flagged.

  3. 03

    Insulation and slope

    We lay the boards so water runs to the drains.

  4. 04

    Weld and seal

    Seams are welded, and every edge is detailed.

  5. 05

    Walk-through

    We inspect together, then clean up.

Reflective white TPO roof in full sun on a Brooklyn building
Worth doing?

Why replace with TPO

Cooler top floor One welded sheet Warranty-backed

A white, reflective surface keeps the top floor cooler in summer. Welded seams behave like one sheet, so there are fewer places for a leak to start, and a good install carries a warranty and lasts for many years.

Would you like to keep it that way? See keeping the new membrane in good shape after install.

Attachment methods

The different ways TPO is attached

Method Fully adhered Mechanically fastened
How it goes on Glued to the insulation Screwed down along the seams
Best for Tight, quiet-looking surfaces, parapet-heavy roofs Large open roofs
What to know More labor, smoother finish Faster, and the fasteners sit under the seams

Swipe to see both methods

Thickness in mil

Membrane thickness, measured in mil, matters too.

Overlay or tear-off

Overlaying an existing membrane is sometimes possible, but only when the roof underneath is dry and sound. Otherwise it is a full tear-off.

Brownstone to warehouse

Brooklyn buildings we re-roof

Brownstones and row houses

Tight access and shared parapets.

Multi-family and apartment buildings

Many drains and penetrations.

Mixed-use and retail

Roofs that must stay dry over active businesses.

Warehouses and restaurants

Large areas and rooftop equipment.

FAQ

TPO roof replacement FAQ

01Is it a tear-off or an overlay?

It depends on the roof underneath. If it is wet or failing, we tear off. If it is dry and sound, an overlay may work.

02How long does the job take?

Brooklyn roofs usually take a few days, depending on size and weather.

03What warranty comes with it?

The membrane carries a manufacturer warranty, and we explain the terms in writing. Curious how it stacks up against rubber? See how TPO compares with a rubber EPDM roof.

04Is the white membrane worth it in Brooklyn?

Yes, for most flat roofs. It reflects heat and helps keep the building cooler.

Free estimate

Get your free estimate

Ready to replace your TPO roof the right way? Call (929) 295-4523 or Free estimate. Want to spread the cost? Look at paying for the roof over time.