Rubber roof leak repair · Brooklyn

EPDM Roof Leaks: Repair in Brooklyn, NY

EPDM roof leaks are what BST Roofers traces to the true source and repairs, usually the same day when the leak is active. The usual culprits are separated seams, failed flashing, cracked pipe boots and clogged drains.

Flat EPDM rubber roof on a Brooklyn row house, with seams, parapet flashing and a drain where a leak is being traced
Usual sources
  • Separated seams
  • Failed flashing
  • Cracked pipe boots
  • Clogged drains
Six failure points

Where EPDM roofs leak

We check these six spots on every rubber roof before we name a fix.

01

Seams

The glued laps pull apart as the rubber ages.

02

Parapet flashing

The tie-in to the wall cracks or lifts.

03

Pipe boots

Rubber collars split around penetrations.

04

Drains and scuppers

Debris backs water up onto the membrane.

05

Punctures

Foot traffic and dropped tools open small holes.

06

Edge shrinkage

The membrane tightens and pulls loose.

Cause, repair, time

The repair that matches the cause

Each cause has its own fix, and most take hours, not days.

CauseRepairTypical fix time
Open seamClean and re-sealHours
PunctureReinforced patchHours
FlashingReplace or re-flashHalf day to a day
Boot or drainNew boot, cleared drainHours
Wet insulationCut out, dry, replaceOne to two days

Swipe to see the full table

Wet insulation is removed, never covered. See our other flat-roof leak repairs.

From call to dry roof

What happens after you call

Four steps, in the same order on every leak call.

BST Roofers crew on a Brooklyn flat roof checking an EPDM seam and the insulation beneath it
Same day

Usually, when the leak is active.

  1. 01
    DispatchWe dispatch a crew to your roof.
  2. 02
    TraceWe trace the leak and check for wet insulation.
  3. 03
    RepairWe make the roof watertight.
  4. 04
    EstimateWe give a written estimate for any larger work.
Small leak, big bill

Why fixing a leak early pays off

A small leak rarely stays small. Water soaks the insulation and deck, then shows up as ceiling stains and mold.

On brownstones, row houses and mixed-use buildings, an early repair keeps a rubber roof working for years.

  • Small leak
  • Wet insulation
  • Stains and mold
Top-floor ceiling in a Brooklyn brownstone kept dry after an early EPDM leak repair on the roof above
Roofs we keep going
  • Brownstones
  • Row houses
  • Mixed-use buildings
From small to large

The different ways a leak gets fixed

Smallest fix

Patch

A small puncture or splitgets a reinforced patch.

Mid-size fix

Re-seal

Open seams and lifted flashingare cleaned and bonded again.

Largest fix

Section or full re‑roof

A worn area is replaced,or the whole membrane.

Costs are in what a patch versus a larger repair costs. If the membrane is past saving, read when the membrane is past repair.

Straight answers

EPDM roof leak FAQ

Can a leaking EPDM roof be patched?
Yes. Punctures, seams and flashing failures are usually repaired without replacing the roof.
How do you find a leak with no visible hole?
We check seams, flashing and penetrations, then test for wet insulation beneath the membrane.
How fast can you come for an active leak?
Usually the same day. Meanwhile, read what to do while the leak is active.
Is a repair covered by a warranty?
Yes, our finished work carries a warranty.
Leaking rubber roof

Get your free estimate

Is water coming through a rubber roof right now? Call (929) 295-4523 and we will send a crew.